![]() Loaded: loaded (/usr/lib/systemd/system/rvice static vendor preset: disabled)Īctive: active (running) since Wed 12:47:18 PST 23h ago You can check this with the systemctl status command: # systemctl status rvice It’s probable that D-Bus is already installed and started. If you would like all clients to access the Master Print Server, then use “ Allow all” instead of “ Allow enable, and start the D-Bus service. In nf, add Allow to the bottom of the stanza so It looks like the following: Īllow will allow clients on the “local” network (the subnet on which the Master Print Server is located) to access CUPS on the Master Print Server. If you would like to limit CUPS to listening on a particular interface, enter the IP address of that interface instead of * or 0.0.0.0. This will configure CUPS to listen on all network interfaces. Stop CUPS and back up your current CUPS configuration: # service cups stopĮdit /etc/cups/nf to allow other servers to connect to printers on the master server. How do I set up a master print server using CUPS in RHEL? CUPS Master Print Server Configuration ![]() This method of printer sharing should be compatible with the Apple-branded “Bonjour” (sometimes called “Zeroconf”) system found in MacOS X.įor other methods of printer sharing and discovery using CUPS, please see the following Knowledgebase Solution: The mDNS/DNS-SD protocols are implemented using Avahi and D-Bus in CentOS 7 and Rocky Linux 8. ![]() This method of printer sharing and discovery uses a set of service protocols (“multicast DNS” and “DNS Service Discovery”) that enables clients to discover shared printers on the master servers. How can I use Avahi and cups-browsed to share printers in CentOS 7.7 and Rocky Linux 8
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |